EL 2000 HS High Speed DC Electronic Loads
The EL 2000 HS Series is a high speed DC load providing point of load (POL) connections and point of use (POU) for high slew rate DC loading. The EL 2000 HS is a stand-alone modular load for testing one device or group modules together for multi device testing. The smart on-board load head minimizes inductance, resistive losses and noise associated with typical loads that use wires to connect the device under test (DUT) to the load. With the increasing demand for high speed semiconductors, operating voltages are decreasing for minimizing the heat dissipation in devices. The EL 2000 HS is designed for sub 1V testing to meet the demands of low voltage devices.
Key Features of the EL 2000 HS DC Electronic Load
- Smart on-board load head (minimizes inductance)
- High speed slew rates
- High speed digitizer for high sampling rates
- 4 modes of operation; CC, CR, CP and CV
- Ethernet control and read back
- Standard and custom solutions available
- Modular stand-alone design
- High speed transient response loading
- Sinks full rated current with only 0.3V applied to load head
EL 2000 HS
Testing VRM, VRD, Semiconductors and Similar Devices
The EL 2000 HS dc electronic load provides a platform that is flexible using its smart on-board head design and modular load modules for positioning POL connections for minimizing inductance that will reduces the speed of current transitions, rate of change of current in that path (di/dt) (V = L*di/dt), faster current demands or pulses result in higher voltage drops for a given inductance. When you add the benefits of high speed control and sampling our loads offer full functionality for your testing needs.
Testing High Bandwidth Power Supplies
Most conventional electronic loads with cables connections cannot meet the demands of high bandwidth power supplies. This is a very common problem with power supplies for military and commercial applications where the power supply is delivering power to RF modules. The EL 2000 HS high speed DC load is designed for all the factors that contribute to the inductive path to the load’s power section by utilizing POL /POU modules and low internal inductance. The overall inductance of the current path is reduced by designing for the following; the connection interface to the power supply under test, the power transmission path, the critical current path inside the electronic load and the component selection along the path inside the electronic load. As the voltage drop V along a current path is directly proportional to the product of the inductance in that path (L) and the rate of change of current in that path (di/dt) (V = L*di/dt), faster current demands or pulses result in higher voltage drops for a given inductance. Therefore, the faster the current demand the greater the voltage drop and hence lower the voltage actually seen across the load device. Low inductance allows for fast rise and fall times at low voltages.
Figure 1 and 2 are typical rise and fall times. Notice hat over and undershoot are minimized but the advanced control feedback loops.
Figure 1: 348.7ns, 20A rise time
Figure 2: 597.6ns, 20A fall time